Bernina Artista 640 Manuel d'instructions télécharger pdf (Page 114)

114 Preparing for Embroidery

Embroidery Presser Foot No. 26

• attach the Embroidery presser foot

No. 26

• raise the presser foot so that the

embroidery hoop can be attached

Needles for Embroidery

• depending on the embroidery thread use

needle size 75 to 90

• use special embroidery or Metafil needle

for embroidery or metallic thread

• use an undamaged needle

• raise the needle so that the embroidery

hoop can be attached

Straight Stitch Plate (optional accessory)

• the straight stitch plate has a small needle

hole. The needle insertion points (upper

and lower thread stitching) are limited,

which produces a better embroidery result

•remove the standard stitch plate and

replace it with the straight stitch plate

Threading the Upper Thread

• attach foam pad and place the upper

thread spool

• when using Rayon or slippery embroidery

threads, slip the net over the upper thread

spool

• this prevents the upper thread from

slipping and gives an even thread feed

Bobbin thread tension

• insert the thread into the pigtail tension

guide for embroidery.

Lower the Feed Dog

•press the button on the right side of the

sewing computer to lower the feed dog

Preparing the Embroidery Computer for Embroidery

Threading Upper and Bobbin Thread

16

17

19

10

13

Spool pin

When using metallic or

specialty threads, using the

vertical spool pin and the

supplementary thread guide

(optional accessory) may also

help avoid problems.

While embroidering the bobbin

can also be wound, just like in

sewing.





Lower thread indicator sensor

will only work when the bobbin

cover is closed, after inserting

the embroidery bobbin case.

(Sensor has to be activated in

the Setup Program.)

031508.50.04_0601_a640_EN

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 167 168

Commentaires sur ces manuels

Pas de commentaire